2008-09 WRX Map Information

[ev8siv3]

How do your maps run on stock air filters? I don't really like the filtration efficiency of the K&N, and I operate the car in a fairly dusty environment.

Interesting how close my EDM map is to the USDM one eh? The biggest difference I can see is in the DBW maps. EDM version has more linear response to the pedal input where the USDM ones have very exaggerated response above about 70% pedal angle. I wonder if that has anything to do with the different gearing? The EDM car has 4.444:1 final drive ratio, as reflected in the rev/mile tables.

They may run a bit leaner in some cases. I was unaware the newer WRX's in EU came with a 4.444 as I have not had time to dive into the rom or research the vehicle yet. Can you get me some screenshots from the factory manual that shows the gear ratios/fd ratios etc..?

They may run a bit leaner in some cases. I was unaware the newer WRX's in EU came with a 4.444 as I have not had time to dive into the rom or research the vehicle yet. Can you get me some screenshots from the factory manual that shows the gear ratios/fd ratios etc..?

Sure. Just let me know what else you need.

WRX's SADM(mine) also have 4.44 final gear!

I have been running XPT stage 2 map since october/2009 and all is going right!! , and including that Costa Rica(contry I live) is like 2500ft or more from the sea.And gasoline is CRAP here.

Braden I have some logs, I will put them in the costumer area

fvs what's you ROM ID? mine is AZ1E400E

did you downloaded the USDM version and used the maps or there's a ready version for it?

WRX 2008 stage 2 with aem cai can work with catback(2.5 or 3 ") or perrin TMIC or both?

[ev8siv3]

WRX 2008 stage 2 with aem cai can work with catback(2.5 or 3 ") or perrin TMIC or both?

Both are fine for the Stage 2.

excuse the ignorance but I bought the map a few months ago but in website says stage 2 is for panel filter k&n or AEM cai and downpipe.
These mods really works with this map ? ( catback and perrin tmic)
I buy a 3 inch catback and a perrin TMIC but i have not yet installed, is recommended or safe this installation?