? about xpt stage 2.5

I have a 2005 wrx and I recently picked up a barely used vf34. I was looking at your maps on your online store and saw that it said they were for vf30, 34, and 39 series turbos. However, when I actually clicked on the stage 2.5 05 wrx with launch control link, it only mentioned the vf39. Would I be able to run this map for my vf34? Thanks!

[ev8siv3]

I have a 2005 wrx and I recently picked up a barely used vf34. I was looking at your maps on your online store and saw that it said they were for vf30, 34, and 39 series turbos. However, when I actually clicked on the stage 2.5 05 wrx with launch control link, it only mentioned the vf39. Would I be able to run this map for my vf34? Thanks!

Great question! The VF39 map can be used with the VF34 as they are very close in mapping. You can make adjustments to the WG DC% to take advantage of the slightly better top end flow of the 34.

thanks a lot! this is a great forum/place. thumbs up to you man

well tomorrow night i will be installing my vf34 along with your map, wrx 565cc (these will be ok, seeing as they are very close to sti pinks right?), a gm bcs, a walbro 255fp and the sti tmic i already have installed.

Will those injectors be ok?

[ev8siv3]

well tomorrow night i will be installing my vf34 along with your map, wrx 565cc (these will be ok, seeing as they are very close to sti pinks right?), a gm bcs, a walbro 255fp and the sti tmic i already have installed.

Will those injectors be ok?

Yeah just change the scaler to 550.67 and copy the latency from the 06 WRX.

thanks

Ok, got everything installed but i have a slight issue. If i rev over 5500 and let of the gas i get a check engine light (flash) guessing it's a knock indicator? and if i got from 2nd to 3rd and wot, it feels like it "breaks up"? just trying to see if you might have an idea. O and my buddy scaled the injectors down, but how do you set it to 06 wrx latency?

[ev8siv3]

Ok, got everything installed but i have a slight issue. If i rev over 5500 and let of the gas i get a check engine light (flash) guessing it's a knock indicator? and if i got from 2nd to 3rd and wot, it feels like it "breaks up"? just trying to see if you might have an idea. O and my buddy scaled the injectors down, but how do you set it to 06 wrx latency?

Sounds like they aren't setup properly for your map. Open up a STOCK 2006 wrx rom and copy the latency values from there to your map.

Well we figured it out. Somehow, the ground wire on top of the intake manifold on the drivers side was loose. Tightening that fixed everything. The map runs great along with the car. Thanks for the responses and for making awesome maps!

Sorry to bump an old thread, but there doesnt seem to be any ADM stage 2.5 maps??

Can these be generated? I have a 2005 ADM WRX, sti pinks, VF36 with a P20 housing and upgraded fuel pump. I also have a Spec C TMIC.

Any help would be grateful

[ev8siv3]

Sorry to bump an old thread, but there doesnt seem to be any ADM stage 2.5 maps??

Can these be generated? I have a 2005 ADM WRX, sti pinks, VF36 with a P20 housing and upgraded fuel pump. I also have a Spec C TMIC.

Any help would be grateful

Unfortunately the VF36 wouldn't be compatible for that map. Everything else would just about line up however.

Hey mate

The VF36 has a single scroll exhaust housing, a P20, so its basically the same as a VF34 with a P20 except I have titanium compressor wheel on bearings not bushes

The problem I have is your store doesn't have any ADM stage 2.5 maps, only USDM.

Where could I get an ADM for my 2005 WRX? I'm in australia.

Are you guys able to build one? Im willing to pay of course